Основни факти

Ceresit CP 30
1-компонентна силиконово-каучукова хидроизолация за покриви

Еластично еднокомпонентно силикон-каучуково покритие за хидроизолация на покриви


  • устойчиво на ултравиолетови лъчи и атмосферни условия
  • пропускливост на водни пари
  • постоянна гъвкавост и при ниски температури
  • може да се нанася и чрез пръскане
  • лесно почистване на инструментите с вода


Не съдържа разтворител, готова за употреба сили кон-каучукова емулсия за безшевна и запълваща пукнатините повърхностна защита и хидроизола ция за покриви. Сертифицирана като хидроизола ционно покритие в съответствие с изискванията на ETAG 005. Особено подходящо за реконструкции и ремонти на течове, свързване на покриви и местата за тръби.

Стъпка по стъпка

Substrate preparation

The substrate must be sound, clean, free of dust and grease as well as dry or only slightly damp (max. 5 % residual moisture). Mechanically remove moss, algae and lichen as well as loose particles and coatings.

When using Ceresit CP 30 Aquablock Coating on still tight roofs only as a protection layer against UV radiation and weathering, a wet layer of 1.0–1.5 mm thickness is sufficient. The seams and joints of bituminous roofing membranes or fiber cement boards must first be covered with CP 30 Aquablock Coating. The final coat can be applied after a drying time of 10–12 hours, or longer depending on the weather.

Sealing coat When using CP 30 Aquablock Coating for waterproofing ac - cording to the requirements of ETA, it is necessary to apply two layers with CP 28 Aquablock Vlies embedded into the first layer. The first layer is applied onto the pre pared and, if necessary, primed substrate with a wet layer thickness of 1 mm. CP 28 Aquablock Vlies should then be rolled and pressed into the freshly coated surface, free of blisters and folds, with an overlap of 10 cm. Always align the over - lapping seams in the direction of water flow. Apply only as much CP 30 Aquablock Coating as can be covered with CP 28 Aquablock Vlies before a start of skin formation. Soak a short-pile roller in CP 30 Aquablock Coating and roll the fleece down into the first coat so that it is fully embedded. Wait until the first layer has fully dried (waiting time approx. 24 hours, sometimes longer depending on the weather) before applying the second coat. Check whether the coat is ready for foot traffic.

Roof inspection and Maintenance: After complete drying of the applied waterproofing coat, it is possible to install additional walkways on the surface with the help of CP 30 Aquablock Coating top coat. It is recommended to use a contrasting color for these areas and a layer thick ness of 1.0 mm. Sprinkle quartz sand (e.g. grit 0.1– 0.4 mm) into the fresh top coat of the service walkways to prevent slipping.